Our premium Stair Kits!

As a general rule, please allow two spindles per tread, and then deduct two spindles for the top and bottom newel posts to determine the total number of spindles required for your staircase.

For the landing, measure the length of rail between posts (in millimetres) and divide the total by 112.

Please note, this formula works for 32mm and 41mm sized spindles.

900mm length spindles can be used on both the staircase and landing areas.

Building regulations state that a sphere of 100mm diameter must not be able to pass between two spindles on a staircase or landing area.

A Sliding Bevel is the simplest way to find the pitch of your stairs. This can be transferred to your spindles and handrail to ensure you cut at the right angle.

TOP TIP – Cut one spindle and insert it in the grooves between the hand and base rail. Slide the spindle up and down the entire length of the rail to highlight any differences in height along the full length of the rail.

Never cut all your spindles in one go. Cut three or four and fit them before moving on to your next batch. If your handrail is slightly “out”, then the distance between the Hand and Base Rail may get larger or smaller as you move up the stairs. By cutting just a few at a time, this will allow you to adjust your spindle length as you go.